academyniom.blogg.se - Mullvad pfsense wireguard

Configured an incoming port forward for a different LAN device unrelated to the VPN.

Attached a device on my LAN to the VPN in Firewalla and confirmed that it works.

Configured a forwarding port on my Mullvad account for the city I use.

Configured 3rd party VPN Wireguard client to Mullvad.

Please note: If you plan to use a Multi-hop setup please see this guide and make the required adjustments to the port in the Endpoint Address & public key in the Peer Public Key fields.I am attempting to configure one of my devices on my LAN to use the Mullvad Wireguard VPN connection configured on my Firewalla Purple with an incoming forwarded port. Reboot your router and wait for a minute or two for everything to settle, then reboot your computer system.Ĭheck the assigned public IP address on our website and run a leak test at from one of the devices connected to your DD-WRT router. Specify one of the following DNS servers in the Static DNS 1 field: The Endpoint Address and Peer Public Key in the example above are specific to our server in Sweden.Ĭlick the Save button, then click the Apply Settings button.

Note: You are welcome to use whichever server you prefer. Peer Public Key: Enter an IVPN WireGuard server public key (available on the Server Status page).Endpoint Address: Enter an IVPN WireGuard server hostname (available on the Server Status page) and choose a port:.10.0.254.3 = AntiTracker Hardcore Mode to also block Google and Facebook.10.0.254.2 = standard AntiTracker to block advertising and malware domains.172.16.0.1 = redular DNS with no blocking.Peer Tunnel DNS: Specify one of the following DNS servers:.

This will prevent out-bound traffic when the VPN client is disconnected from the server.Ĭlick the Add Peer button and enter the following peer configuration (as also shown in the screen shot below): This will display details of the WireGuard connection including the public key, which can be easily copied. Click the Save and Apply Settings buttons, then go to Administration > Commands and enter wg in the Commands box, then click Run Commands. Hint: After clicking Generate Key, it may or may not be possible to copy the public key displayed on the Tunnels page.